Most of you know by now that my schedule has been a little packed lately due to a long series of commissions. I promised you that once they were over, I would be able to focus nearly all of my efforts on The Wood Whisperer. And now its time to deliver. I am finally on the last of that series of projects and will be done within the next 7-10 days. This particular episode represents a taste of whats to come. With some new editing software, a new camera, and a little more knowledge and experience on my part, we are able to offer higher quality videos and higher quality content. The new format of the show represents what we would like to think of as “Season 2″. I hope you enjoy it. I would have to say the most commonly requested episode so far has been dovetails. Handcut, machine cut, through or half blind……..you guys love your dovetails! Well, I have held off for a while because I wanted to make sure I did the process justice. This particular episode is a glimpse into the world of machine-cut through dovetails. Even though the episode is 30 minutes long, I feel like I just barely scratched the surface. The devil is in the details! And each jig differs in those little details. Fortunately, there are some common elements to all these jigs that make this episode useful to anyone, regardless of what jig you use. I happened to use what I consider to be the best jig on the market: the Leigh D4R. No matter what jig you use or even if you cut them by hand, there’s no denying the “cool factor” surrounding dovetails. If you haven’t made them yet, they are easier than they look and it is certainly worth your time to learn the process. So watch the video and find out what it sounds like, when dovetails cry………. ***Error note*** Thanks to Steve and Brian in the comments section for bringing this to my attention. During the filming of the podcasts, I was using “props” for my cuts and consequently was not as careful with my organization as I should